Saturday, December 3, 2011

Sound Activated Lamp.


This simple circuit shown int the schematic diagram actives the switch using sound. We can use this circuit for various applications, such as automatic (sound-controlled) disco light or car’s LED light show. The Q1 amplify the audio from mic. The R1 is used to adjust the peak of signal to greater than about 0.7 volts, act as sensitivity adjuster. A certain level, the signal coming from microphone, after amplification by Q1, will trigger the SCR and light lamp I1. If we change the lamp with a relay, then we can get a sound-activated relay/switch, which can be used to control more powerful / high wattage high voltage lamps. If we use a relay, place a 1N4007 diode in parallel with the relay coil to prevent the back-emf from relay coil destroying the SCR.

List Component :
R1 >> 1K
R2 >> 4.7K
R3 >> 1K
VR1 >> 5K
C1 >> 0.47 mf/16V
Q1 >> HEP802
SCR >> C103

No comments:

Post a Comment